Command Descriptions
2–46
TDS Family Oscilloscope Programmer Manual
!
or or = 0 stops acquisitions.
or or 0 starts acquisition and display of waveforms. If the
command was issued in the middle of an acquisition sequence (for instance
averaging or enveloping), restarts the sequence, discarding any data
accumulated prior to the . It also resets the number of acquisitions.
starts acquisition of waveform data and resets the number of acquisitions count
(NUMACQ) to zero.
returns either or , depending on whether the acquisition system is running.
ACQuire:STOPAfter
Tells the digitizing oscilloscope when to stop taking acquisitions. This is
equivalent to setting Stop After in the Acquire menu.
Acquisition
ACQuire:MODe, ACQuire:STATE, ACQuire:REPEt
! " # ! # $
!
!
!
Arguments
Examples
Group
Related Commands
Syntax
To Next Page
Loading...
Need help?
General
