Command Descriptions
2–204
TDS Family Oscilloscope Programmer Manual
*RCL (No Query Form)
Restores the state of the digitizing oscilloscope from a copy of its settings stored
in memory. (The settings are stored using the *SAV command.) This command
is equivalent to RECAll:SETUp and performs the same function as the Recall
Saved Setup item in the front-panel Save/Recall Setup menu.
Save and Recall
DELEte:SETUp, FACtory, *LRN?, RECAll:SETUp, *RST, *SAV, SAVe:SETUp
is a value in the range from 1 to 10, and specifies a setup storage location.
Using an out-of-range value causes an execution error (222, “Data out of range”).
restores the digitizing oscilloscope from a copy of the settings stored in memory
location 3.
RECAll:SETUp (No Query Form)
Restores a stored or factory front-panel setup of the digitizing oscilloscope. This
command is equivalent to selecting Recall Saved Setup or Recall Factory
Setup or Recall Current Setup in the Save/Recall Setup menu.
Save and Recall
DELEte:SETUp, FACtory, *RCL, *RST, *SAV, SAVe:SETUp
Group
Related Commands
Syntax
Arguments
Examples
Group
Related Commands
Syntax
To Next Page
Loading...
Need help?
General
