Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–75
CURSOR:PAIRED SNAP
specifies the positions of the cursors are at the current DATA:START and
DATA:STOP values.
CURSOR:PAIRED?
might return :CURSOR:PAIRED:UNITS BASE;POSITION1 -2.00E-3;POSITION2
2.00E-3;SELECT CURSOR2.
CURSor:PAIred:HDELTA (Query Only)
Queries the hbar (voltage) distance between the first and second paired cursor.
This is the absolute value of the vertical position of the first cursor minus the
vertical position of the second cursor.
Cursor
CURSor:FUNCtion
CURSor:PAIred:HDELTA?
CURSor
:
PAIred :
?
HDELTA
CURSOR:PAIRED:HDELTA?
might return 5.08E+0 for the voltage difference between the two cursors.
CURSor:PAIred:HPOS1 (Query Only)
Queries the horizontal bar (voltage) position of the first paired cursor.
Cursor
CURSor:FUNCtion
CURSor:PAIred:HPOS1?
CURSor
:
PAIred :
?
HPOS1
CURSOR:PAIRED:HPOS1?
might return -64.0E-3, indicating that the first cursor is at –64.0 mV.
Examples
Group
Related Commands
Syntax
Examples
Group
Related Commands
Syntax
Examples
To Next Page
Loading...
Need help?
General
