Command Descriptions
2–110
TDS Family Oscilloscope Programmer Manual
SCROLLBAR specifies the color of the scrollbar. For example, you will find a
scrollbar in various file system menus.
<NR1>, <NR1>, <NR1> specifies the desired colors in terms of hue, lightness
and saturation values.
Hue is the wavelength of light reflected from the surface. It varies continuously
along the color spectrum as produced by a rainbow. Values range from 0 to 359.
Sample values are: 0 = blue, 60 = magenta, 120 = red, 180 = yellow, 240 =
green, 360 = cyan.
Lightness refers to the amount of light reflected from the surface. It varies from
black, to the nominal color, to white. Values range from 0 to100. A value of 0
results in black. A value of 50 provides the nominal color. A value of 100 results
in white.
Saturation is the intensity of color. Completely desaturated color is gray.
Completely saturated color of any hue is that color at its most intense. Values
range from 0 to 100. A value of 100 provides a pure color. A value of 0 provides
gray.
DISPLAY:COLOr:PALEtte:HARDCOPY:CH1 120,50,100
sets the CH1 color of the hardcopy palette to 120 hue, 50 lightness, and
100 saturation. This provides a pure red.
DISplay:FILTer
Sets or queries the type of interpolation to use for the display when the DIS-
play:STYle is VECtors. This command is equivalent to setting Filter in the
Display menu.
Display
DISplay:STYle
DISplay:FILTer { LINEAr | SINX }
DISplay:FILTer?
Examples
Group
Related Commands
Syntax
To Next Page
Loading...
Need help?
General
