Command Descriptions
2–200
TDS Family Oscilloscope Programmer Manual
PASSWord, *PUD
is the new password. The password can include up to 10 characters.
creates a new password for accessing the user protected data.
*OPC
Generates the operation complete message in the Standard Event Status Register
(SESR) when all pending operations finish. The *OPC? query places the ASCII
character “1” into the output queue when all pending operations are finished. The
*OPC? response is not available to read until all pending operations finish. For a
complete discussion of the use of these registers and the output queue, see page
3–1.
Status and Error
BUSY?, *WAI
The *OPC command allows you to synchronize the operation of the digitizing
oscilloscope with your application program. Synchronization methods are
described starting on page 3–7.
Related Commands
Syntax
Arguments
Examples
Group
Related Commands
Syntax
To Next Page
Loading...
Need help?
General
