Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–297
is the number of data points. If DATa:WIDth is 2 then there are twice as
many bytes.
= 0 means that the waveform record is of an unspecified length.
might return as the number of data points in the waveform record trans-
ferred from channel 1.
WFMPre:<wfm>:PT_Fmt
Selects the data point format for the first ordered waveform as selected by the
DATa:SOUrce command. On input <wfm> always defaults to the reference
location specified by DATa:DESTination regardless of what is sent.
Waveform
DATa:DESTination
!"
specifies that the waveform is transmitted as minimum and maximum point
pairs. Only y values are explicitly transmitted. Absolute coordinates are given
by:
X
n
0 XINcr (n PT_Off)
Y
n
min
YZEro YMUlt (y
n
min
YOFf)
Arguments
Examples
Group
Related Commands
Syntax
Arguments
To Next Page
Loading...
Need help?
General
