xi
TableĂ1Ć1:ăRecord Length versus Divisions per Record, Samples
per Division, and Sec/Div Sequence 1Ć3........................
TableĂ1Ć2:ăNominal Traits Ċ Signal Acquisition System 1Ć9...........
TableĂ1Ć3:ăNominal Traits Ċ Time Base System 1Ć10..................
TableĂ1Ć4:ăNominal Traits Ċ Triggering System 1Ć10..................
TableĂ1Ć5:ăNominal Traits Ċ Display System 1Ć11....................
TableĂ1Ć6:ăNominal Traits Ċ GPIB Interface, Output Ports, and
Power Fuse 1Ć11..............................................
TableĂ1Ć7:ăNominal Traits Ċ Mechanical 1Ć12........................
TableĂ1Ć8:ăWarranted Characteristics Ċ Signal Acquisition System 1Ć13.
TableĂ1Ć9:ăWarranted Characteristics Ċ Time Base System 1Ć14........
TableĂ1Ć10:ăWarranted Characteristics Ċ Triggering System 1Ć15......
TableĂ1Ć11:ăWarranted Characteristics Ċ Output Ports, Probe
Compensator, and Power Requirements 1Ć15....................
TableĂ1Ć12:ăWarranted Characteristics Ċ Environmental 1Ć16..........
TableĂ1Ć13:ăTypical Characteristics Ċ Signal Acquisition System 1Ć19...
TableĂ1Ć14:ăTypical Characteristics Ċ Time Base System 1Ć20.........
TableĂ1Ć15:ăTypical Characteristics Ċ Triggering System 1Ć20..........
TableĂ1Ć16:ăTypical Characteristics Ċ Data Handling and Reliability 1Ć22
TableĂ2Ć1:ăPowerĆCord Conductor Identification 2Ć8..................
TableĂ2Ć2:ăEffects of Corrupted Data 2Ć10............................
TableĂ4Ć1:ăTest Equipment 4Ć14....................................
TableĂ4Ć2:ăDC Offset Accuracy (Zero Setting) 4Ć22....................
TableĂ4Ć3:ăDC Accuracy 4Ć27.......................................
TableĂ4Ć4:ăAnalog Bandwidth 4Ć30.................................
TableĂ5Ć1:ăCalibration Tests 5Ć3....................................
TableĂ5Ć2:ăAdjustments Required for Module Replaced 5Ć4...........
TableĂ5Ć3:ăAdjustments and Dependencies 5Ć4.....................
TableĂ5Ć4:ăTest Equipment, Fixtures, and Supplies 5Ć5...............
TableĂ5Ć5:ăGPIB Board Configuration1 5Ć7..........................
TableĂ6Ć1:ăRelative Susceptibility to StaticĆDischarge Damage 6Ć3.....
TableĂ6Ć2:ăExternal Inspection Check List 6Ć6.......................
TableĂ6Ć3:ăInternal Inspection Check List 6Ć7........................
TableĂ6Ć4:ăTools Required for Module Removal 6Ć11...................
TableĂ6Ć5:ăNormal Supply Voltages (Measured on J26 and J27
on the A11 DRAM Processor/Display Module) 6Ć69................
TableĂ6Ć6:ăNoĆLoad Supply Voltages (Measured on J5 and J6
on the A17 Main LV Power Supply Module) 6Ć69...................
TableĂ7Ć1:ăInternational Power Cords 7Ć1...........................
To Next Page
Loading...
