Command Descriptions
2–226
TDS Family Oscilloscope Programmer Manual
specifies a preset ECL level of –1.3 V.
specifies a preset TTL level of 1.4 V.
is the delayed trigger level, in volts.
sets the delayed trigger level to 2 mV.
TRIGger:DELay:TIMe
Sets or queries the delay time when HORizontal:DELay:MODe is set to
TRIGAfter. This command is identical to the HORizontal:DELay:TIMe:TRIG-
After command, and is equivalent to setting the Delay by Time value in the
Delayed Edge Delay side menu.
When HORizontal:DELay:MODe is set to RUNSAfter, the delay time is set by
the HORizontal:DELay:TIMe:RUNSAfter command.
Trigger
HORizontal:DELay:MODe, HORizontal:DELay:TIMe:RUNSAfter, HORizon-
tal:DELay:TIMe:TRIGAfter
is the delay time, in seconds.
Arguments
Examples
Group
Related Commands
Syntax
Arguments
To Next Page
Loading...
