Command Groups
TDS Family Oscilloscope Programmer Manual
2–37
Zoom Commands
Zoom commands let you expand and position the waveform display horizontally
and vertically without changing the time base or vertical settings. Table 2–22
lists these commands.
Table 2–22: Zoom Commands
Header Description
ZOOm Reset zoom parameters to defaults
ZOOm:DUAl (TDS 400A, 500B, 600B, & 700A) Turn dual zoom mode on and off
ZOOm:DUAl:OFFSet
(TDS 400A, 500B, 600B, & 700A)
Adjust the requested horizontal offset between
the centers of the main and second zoom
boxes
ZOOm:GRAticle
(TDS 400A, 500B, 600B, & 700A)
Select between the upper and lower graticule
for use by the zoom preview state
ZOOm:HORizontal:LOCk Horizontal zoom lock
ZOOm:HORizontal:POSition Horizontal zoom position
ZOOm:HORizontal:SCAle Horizontal zoom scale
ZOOm:STATE Turn zoom mode on or off
ZOOm:VERTical:POSition Vertical zoom position
ZOOm:VERTical:SCAle Vertical zoom scale
To Next Page
Loading...
