Tektronix TDS Series - Page 61

Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–41
ACQuire:NUMAVg, ACQuire:NUMENv, CURVe?, DATa:WIDth
For the TDS 400A, 510A, 500B & 700A:
ACQuire:MODe { SAMple | PEAKdetect | HIRes | AVErage |
ENVelope }
For the TDS 600B:
ACQuire:MODe { SAMple | PEAKdetect | AVErage | ENVelope }
For all TDS:
ACQuire:MODe?
For the TDS 400A, 510A, 500B, & 700A:
ENVelope
HIRes
ACQuire
:
MODe
<Space>
AVErage
PEAKdetect
SAMple
?
For the TDS 600B:
ENVelope
AVErage
ACQuire
:
MODe
<Space>
?
PEAKdetect
SAMple
SAMple specifies that the displayed data point value is simply the first sampled
value that was taken during the acquisition interval. In sample mode, all
waveform data has 8 bits of precision. You can request 16 bit data with a
CURVe? query, but the lower-order 8 bits of data will be zero. SAMple is the
default mode.
PEAKdetect specifies the display of the high-low range of the samples taken
from a single waveform acquisition. The high-low range is displayed as a
vertical column that extends from the highest to the lowest value sampled during
the acquisition interval. PEAKdetect mode can reveal the presence of aliasing or
narrow spikes.
Related Commands
Syntax
Arguments