Tektronix TDS Series - Page 94

Command Descriptions
2–74
TDS Family Oscilloscope Programmer Manual
CURSOR:HBARS:SELECT CURSOR1
selects the first horizontal bar cursor as the active cursor.
CURSOR:HBARS:SELECT?
returns CURSOR1 when the first cursor is the active cursor.
CURSor:HBArs:UNITS
Sets or queries the units for the horizontal bar cursors. This command is
equivalent to setting Amplitude in the Cursor menu.
Cursor
CURSor:HBArs:UNIts { BASe | IRE }
CURSor:HBArs:UNITS?
CURSor
:
HBArs
:
UNIts
<Space>
?
IRE
BASe
BASe specifies base as the unit of measure.
IRE specifies IRE as the unit of measure. These units are typically used with
video signals.
CURSOR:HBARS:UNITS BASE
sets the units for the horizontal bar cursors to base.
CURSOR:HBARS:UNITS?
returns IRE when the horizontal bar cursor units are IRE.
CURSor:MODe
Selects whether the two cursors move together in unison or separately.
Cursor
CURSor:FUNCtion
Examples
Group
Syntax
Arguments
Examples
Group
Related Commands