Command Descriptions
2−134
TDS200/1000/2000 Series Oscilloscope Programmer Manual
SELect:<wfm>
Controls the display of waveforms. This command is equivalent to
activating or deactivating a waveform from the oscilloscope front
panel.
Vertical
SELect:<wfm> { OFF | ON | <NR1> }
SELect:<wfm>?
OFF or <NR1> = 0 deactivates the display of the specified waveform.
ON or <NR1> ≠ 0 activates the display of the specified waveform.
<wfm> can be CH<x>, MATH, or REF<y>. Refer to Constructed
Mnemonics on page 2-8 for more information.
SELect:CH2 ON
displays channel 2.
SELect:REFA?
returns either 0 or 1, indicating whether the REFA waveform is
displayed.
SET? (Query Only)
Returns most oscilloscope settings. You can send these responses
back to the oscilloscope to return the oscilloscope to the state it was
in when you sent SET?. This query is identical to the *LRN? query.
Miscellaneous
Group
Syntax
Arguments
Examples
Group
To Next Page
Loading...
Need help?
General
