Command Descriptions
2−140
TDS200/1000/2000 Series Oscilloscope Programmer Manual
LFRej coupling removes the low-frequency components of the AC
signal.
NOISErej selects DC low sensitivity. It requires added signal
amplitude for more stable, less false triggering.
TRIGger:MAIn:EDGE:COUPling DC
sets the main edge trigger coupling to DC.
TRIGger:MAIn:EDGE:SLOpe
Selects a rising or falling slope for the edge trigger. This is
equivalent to setting the Slope option in the Trigger menu.
Trigger
TRIGger:MAIn:EDGE:SLOpe { FALL | RISe }
TRIGger:MAIn:EDGE:SLOpe?
FALL specifies to trigger on the falling or negative edge of a signal.
RISe specifies to trigger on the rising or positive edge of a signal.
TRIGger:MAIn:EDGE:SLOpe RISE
sets the main edge trigger to occur on the rising slope.
Examples
Group
Syntax
Arguments
Examples
To Next Page
Loading...
