Tektronix TDS1012 - Page 165

Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−147
TRIGger:MAIn:PULse:WIDth:POLarity
NOTE. You can use this command ONLY with the TDS1000 and
TDS2000 series.
Sets or queries the polarity for the pulse trigger. This is equivalent to
setting the Polarity option in the Pulse Trigger menu.
Trigger
TRIGger:MAIn:PULse:WIDth:POLarity
{ POSITIVe | NEGAtive }
TRIGger:MAIn:PULse:WIDth:POLarity?
Positive polarity specifics pulses with a rising leading edge.
Negative polarity specifies pulses with a falling leading edge.
TRIGger:MAIn:PULse:WIDth:WHEN
NOTE. You can use this command ONLY with the TDS1000 and
TDS2000 series.
Sets or queries the trigger conditions for the pulse trigger. This is
equivalent to setting the When option in the Pulse Trigger menu.
Trigger
TRIGger:MAIn:PULse:WIDth:WHEN
{ EQual | NOTEqual | INside | OUTside }
Group
Syntax
Arguments
Group
Syntax