Tektronix TDS200 Series - Page 121

Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−103
*IDN? (Query Only)
Returns the oscilloscope identification code in IEEE 488.2 notation.
NOTE. IDN? must be the last command when it is part of a
concatenated statement. Otherwise the oscilloscope generates event
message 440.
Status and Events
*IDN?
The oscilloscope identification in the following format:
TEKTRONIX,<model number>,0,CF:91.1CT FV:v<oscilloscope
firmware version number> TDS2XX:XXV:v<module firmware
version number>
Where XX is the module type, CM (communications module) or
MM (measurement module).
The *IDN? and ID? responses are slightly different.
*IDN?
might return the response
TEKTRONIX,TDS 220,0,CF:91.1CT FV:v1.00 TDS2CM:CMV:v1.00
ID?
Group
Syntax
Returns
Examples
Related Commands