Need help?Do you have a question about the Tektronix TDS2022 and is the answer not in the manual?
General| Bandwidth | 200 MHz |
|---|---|
| Channels | 2 |
| Sample Rate | 2 GS/s |
| Time Base Range | 5 ns/div to 50 s/div |
| Vertical Resolution | 8 bits |
| Display Resolution | 320 x 240 pixels |
| Input Coupling | AC, DC, GND |
| Timebase Accuracy | 50 ppm |
| Input Impedance | 1 MΩ ± 2% |
| Trigger Types | Edge, Pulse, Video |
| Interfaces | USB |
| Maximum Input Voltage | 300 V |
| Power Requirements | 100 to 240 V ±10%, 45 to 66 Hz |
| Memory Depth | 2.5k points |
Guides through a quick check to verify the oscilloscope's correct operation.
Explains how to manually adjust probe compensation for accurate measurements.
Describes the self-calibration process to optimize signal path accuracy.
Explains how trigger settings determine waveform acquisition and display.
Details acquisition modes like Sample, Peak Detect, and Average.
Covers adjusting waveform display size and location on the screen.
Describes methods for taking measurements using graticule, cursors, or automatic functions.
Details the front-panel controls for setting up triggers.
Shows how to use cursors for time and voltage measurements.
Details how to capture transient events using single-shot acquisition.
Describes the Cursor button and options for voltage and time measurements.
Provides comprehensive information on trigger types, sources, and settings.
To Next Page
