Tektronix TDS200 Series

Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−177
WFMPre:<wfm>:YUNit
Same as WFMPre:YUNit, except that <wfm> specifies the
source/destinaton waveform instead of DATa:SOUrce and
DATa:DESTINATION.
For set commands, if <wfm> is not a reference waveform, the
oscilloscope generates error 2241.
WFMPre:<wfm>:YZEro
Same as WFMPre:YZEro, except that <wfm> specifies the
source/destinaton waveform instead of DATa:SOUrce and
DATa:DESTINATION.
For set commands, if <wfm> is not a reference waveform, the
oscilloscope generates error 2241.