Tektronix TDS200 Series

TDS200/1000/2000 Series Oscilloscope Programmer Manual
Index−1
Index
A
Abbreviating, commands, 2-5
ACQUIRE?, 2-35
ACQUIRE:MODE, 2-36
ACQUIRE:NUMACQ?, 2-37
ACQUIRE:NUMAVG, 2-38
ACQUIRE:STATE, 2-39
ACQUIRE:STOPAFTER, 2-40
Acquisition command group, 2-15
Acquisition commands
ACQUIRE?, 2-35
ACQUIRE:MODE, 2-36
ACQUIRE:NUMACQ?, 2-37
ACQUIRE:NUMAVG, 2-38
ACQUIRE:STATE, 2-39
ACQUIRE:STOPAFTER, 2-40
Address, Tektronix, vii
ALLEV?, 2-41
Argument, command, 2-3
ASCII, 2-1, A-1
AUTOSET, 2-42
AUTOSET:SIGNAL, 2-43
AUTOSET:VIEW, 2-44
B
Block, command argument, 2-12
BNF (Backus-Naur form), 2-1
Break signal, 2-5
BUSY?, 2-45, 3-13
C
*CAL?, 2-46
CALIBRATE:ABORT, 2-47
CALIBRATE:CONTINUE, 2-47
CALIBRATE:FACTORY, 2-48
CALIBRATE:INTERNAL, 2-49
CALIBRATE:STATUS?, 2-49
Calibration and diagnostic com-
mand group, 2-15
Calibration and diagnostic com-
mands
*CAL?, 2-46
CALIBRATE:ABORT, 2-47
CALIBRATE:CONTINUE, 2-47
CALIBRATE:FACTORY, 2-48
CALIBRATE:INTERNAL, 2-49
CALIBRATE:STATUS?, 2-49
DIAG:RESULT:FLAG?, 2-76
DIAG:RESULT:LOG?, 2-77
ERRORLOG:FIRST?, 2-81
ERRORLOG:NEXT?, 2-82
CH<x>, command mnemonic, 2-8
CH<x>?, 2-50
CH<x>:BANDWIDTH, 2-50
CH<x>:COUPLING, 2-52
CH<x>:INVERT, 2-52
CH<x>:POSITION, 2-53
CH<x>:PROBE, 2-54
CH<x>:SCALE, 2-55
CH<x>:VOLTS, 2-56
Channel, command mnemonic, 2-8
Clear status, 2-56
*CLS, 2-56
Command
abbreviating, 2-5
argument, 2-3
block argument, 2-12
BUSY?, 3-13
common, 2-21, 2-24
concatenating, 2-6
definition, 2-4
header, 2-2