Tektronix TDS2022 Programmer's Manual

Command Groups
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−33
3. Use the DATa:WIDth command to specify the number of bytes
per data point.
4. Use the DATa:STARt and DATa:STOP commands to specify the
portion of the waveform that you want to transfer.
5. Use the WFMPRe? command to transfer waveform preamble
information.
6. Use the CURVe? command to transfer waveform data.
To the Oscilloscope. To transfer waveform data to an oscilloscope
waveform storage location, follow these steps:
1. Use the DATa:DESTination command to specify the stored
waveform location.
2. Use the DATa:ENCdg command to specify the waveform data
format.
3. Use the DATa:WIDth command to specify the number of bytes
per data point.
4. Use the DATa:STARt command to specify the first data point in
the waveform record.
5. Use the WFMPRe command to transfer waveform preamble
information.
6. Use the CURVe? command to transfer waveform data.

Tektronix TDS2022 Specifications

General

Brand	Tektronix
Model	TDS2022
Category	Test Equipment
Language	English