7/2014©Tektronix.Allrightsreserved.25W‐30459‐1
Procedure:
1. Push and hold the Main button to enable WFM & VEC mode.
a. Ensure the display is in full screen mode using the Display Select button.
2. Select the Waveform mode, and push and hold this WFM button to enter the menu.
a. Then ensure display type of YPbPr is selected and deselect the Pb and Pr components
to keep only the Y component displayed.
3. In the “Sweep” menu - push and hold the sweep button and choose the Overlay mode then
2-line sweep can be selected.
a. Move trace to the left (as shown in Figure 1) to keep only one line of the waveform
displayed.
4. Now select the 'Vector button and push and hold to bring up the menu and select the display
type (Vector or Lightning).
a. Use the H and V position control to adjust the vector display to the right of the screen.
Note:
Saving this configuration as a preset will allow easy and quick access to this display.
In the 'Sweep' function modes, Line '2' and '2 Field' only work in 'Overlay' mode
You can of course change all of the color display settings within the configuration menu.
.
The Tektronix "TandemVu" Display for Camera Set Up
To Previous Page
Loading...
Need help?
General
