Installation Instructions
WVR6UP, WVR70UP, and WVR7UP Upgrades
23
Perform the following steps to replace the Power Supply cable:
15. To gain adequate clearance to remove the old Power Supply cable and install
the new Power Supply cable, perform the following:
a. If present, disengage the clear plastic P ower Supply shield from the
retaining slot in the fan bracket.
b. Use a 5/16-inch nut driver to loosen the two nuts that secure the fan
bracket to the base of the chassis. Loosen the nuts enough so that you
can slide the Power Supply connector under the bracket.
16. To remove the old P ower Supply cable, disconnect the old cable from the
Power Supply by firmly, but carefully, pulling the cable from the P ower
Supply pins on the Power Supply, and from the Power Supply pins on the
Main board.
WVR6100 and W VR7100
SN B029999 and Below
Only
To Next Page
Loading...
Need help?
General
