Need help?Do you have a question about the Tektronix KEITHLEY 2450-EC and is the answer not in the manual?
General| Model | 2450-EC |
|---|---|
| Channels | 1 |
| Display | 5-inch capacitive touchscreen |
| Manufacturer | Tektronix/Keithley |
| Voltage Range | ±200 V |
| Current Range | ±1 A |
| Connectivity | GPIB |
| Measurement Resolution | 6.5 digits |
| Voltage Measurement Resolution | 100 nV |
Initial setup and configuration of the SMU instrument for electrochemistry tests.
Description of the electrically-shielded 1m cable assembly for SMU connections.
Instructions for connecting the SMU instrument and electrochemical cell using the cable.
Specifies the required parameter settings for the Cyclic Voltammetry test.
Step-by-step guide to initiating and running the Cyclic Volammetry test.
Defines scan rate, potential vertices, and number of cycles for the CV test.
Procedures for saving test results to a flash drive and viewing data.
Parameters for the Open Circuit Potential (OCP) measurement test.
Instructions for starting and executing the OCP measurement test.
Configures potential range, sample count, and sample interval for OCP measurements.
Saving OCP test data to flash drive and viewing results on the instrument.
Defines parameters for potential pulse and square wave tests.
Guide to launching and executing the potential pulse/square wave test.
Adjusts peak/base potential, current range, period, pulse width, and sample time.
Saving pulse test data to flash and accessing saved results.
Specifies parameters for current pulse and square wave tests.
Steps to start and run the current pulse/square wave test.
Sets base/peak current, potential range, period, pulse width, and sample time.
Saving pulse test data to flash and viewing results.
Parameters for Chronoamperometry test, including step potential and duration.
Procedure to start and execute the Chronoamperometry test.
Sets up number of steps, potential levels, durations, and measurement parameters.
Saving Chronoamperometry data to flash and viewing saved results.
Parameters for Chronopotentiometry, including step current and duration.
Guide to starting and running the Chronopotentiometry test.
Defines number of steps, current levels, durations, and measurement settings.
Saving Chronopotentiometry data to flash and accessing results.
To Next Page