-EC, 2460-EC, and 2461-EC Potentiostats And Galvanostats User's Manual Section 2:
077110402/November 2016 2-13
Acquire the open circuit potential (Eoc)
If you selected Eoc as the potential reference for the scan, then the open circuit potential will be
measured immediately after starting the test. You are prompted by the test application, as shown in
the next figure.
Figure 32: Prompt for Eoc measurement
If you select Yes, the instrument measures the open circuit potential (Eoc) of your electrochemical
cell. If you select No, the test stops. After the Eoc is measured, the value is displayed in a prompt, as
shown in the next figure.
Figure 33: Eoc measurement displayed
If this value is acceptable, then select Yes to start the scan. If you select No, the test will stop. The
measured Eoc value is saved in the eocBuffer internal buffer of the instrument.
To Next Page
Loading...
Need help?
General
