Tektronix KEITHLEY 2450-EC - Save or Load the Test Parameter Data

Models 2450
-EC, 2460-EC, and 2461-EC Potentiostats And Galvanostats User's Manual Section 6:
Chronoamperometry
077110402/November 2016 6-7
To select the Sample Time:
1. From the Measure Settings window, select Sample Time.
2. Enter a value, then select OK.
Figure 114: Entering the Sample Time
Save or load the test parameter data
You can save your test parameters to the front-panel flash drive at any time. Up to five test parameter
configurations can be stored.
To save the test parameters:
1. From the Menu screen, select Save Settings. Note that your Menu screen options are different
depending on the test you are running.
If you have saved a settings file previously with the same File Selection number, you will be
prompted to overwrite it.
Figure 115: Selecting Save Settings