Telcoma PASSO - PROGRAMMING - MODIFICATION OF THE OUTPUT RELAY

To Next Page

To Previous Page

PROGRAMMING – MODIFICATION OF THE OUTPUT RELAY

The receiver's output relays are pulse-type, meaning that they activate

for a second following each correct code. To modify them, proceed as

follows:

press and hold the key for approx. 2 seconds until the keypad be-

eps once.

introduce the MASTER code followed by , the LED remains on.

enter to modify the channel output 1 of the receiver or to mo-

dify the channel output 2 (the LED starts to flash).

enter:

for the Step-by-Step mode that is activated with a correct code

and is deactivated after a new correct code

for the pulse mode, 1 second

to for the timer mode where the number corresponds to the

seconds the relay remains energized.

The keypad beeps and the LED switches off.

I want to program relay 1 with the Step-by-Step output

2 sec. MASTER code command step-by-step mode

I want to program relay 2 with the timer output at 120 seconds

2 sec. MASTER code command number of seconds

51# 52#

2# 255#

# 2233# 51# 0#

# 2233# 52# 120#

Example

Example 2

☼