WARNINGS&RESTRICTIONS
IMPORTANT! Tele Radio remote controls are often built into wider applications. We recommend that
the system is provided with a wired emergency stop where necessary.
INSTALLING, CONNECTING AND MOUNTING
n Allow only licensed or qualified personnel to install the product.
n Switch the power supply off to the receiver before connecting the equipment.
n Check that you have connected the power supply to the correct connection
terminal.
n Use undamaged cables. No cables should hang loose.
n Avoid installing in areas affected by strong vibrations.
n Place the receiver well away from wind, damp and water.
n Cable glands and vent plugs must face down to prevent water from seeping in.
THE USER
n Make sure that the user is following the instructions.
n Make sure that the user has reached the certified age of your country to oper-
ate the equipment.
n Make sure that the user is not under the influence of drugs, alcohol and med-
icines.
n Allow only qualified personnel to have access to the transmitter and operate
the equipment.
n Make sure that the user does not leave the transmitter unsupervised.
n Make sure that the user always turns the transmitter off when not in use.
n Make sure that the user keeps a good overview of the work area.
MAINTENANCE
n Always contact your representative for service and maintenance work on the
product.
n Write down the serial numbers/ ID codes of the receivers and transmitters
used. This information should be recorded on the “Settings document” for
your product (download from our website).
n Avoid registering transmitters to receivers where it is not being used.
n Keep the safety instruction for future reference. Always download the con-
figurations instruction from our web site for the latest version available.
- 4 -
To Next Page
Loading...
Need help?
General
