EasyManuals Logo

TELECO AUTOMATION TVRDS868B01 User Manual

TELECO AUTOMATION TVRDS868B01
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
18
9. TROUBLESHOOTING (What to do if...)
Acoustic signals from the control unit
Sequence Meaning Solution
1 costant beep
(continuous or
intermittent)
Faulty control unit Replace the control unit
2 beeps Motor problem - Set the limit switches
- The thermal protection could be activated. Wait while the
motor cools down.
- Check the motor connection
- Test the motor separately by means of a proper tool
3 beeps at
startup
Radio receiver is empty Memorize at least one transmitter
4 beeps
(L1 = OFF)
Radio receiver is full Max. number of transmitter exceeded
4 beeps
(L1 = ON)
Safety test failure: wired
safety edge
- Check the rubber profile general condition
5 beeps
(L2 = ON)
Safety test failure:
wireless safety edge
system
Control unit checks
- The radio card (master) must be correctly inserted in the
plug: check all the pins
- The radio card (master) must be paired with the bottom slat
transmitter (slave)
Bottom slat transmitter checks
- Check type, polarity and charge level of the batteries
- Check functionality by pressing the button
- Check the DIP1 position (at par. 2.2)
- Check wiring between bottom slat transmitter and sensitive
edge (terminals and wire colour)
Sensitive edge checks
- Check the rubber profile general condition
- Check the functionality by means of the testing procedure
with DIP2 (at par. 2.2)
5 quick beeps
every 5 seconds
(L4 flashes)
Low batteries in the
bottom slat transmitter
Replace the batteries as soon as possible. Pay attention to
the polarity.
6 beeps
(L3 = ON)
Safety test failure:
emergency STOP (TB)
Check the safety device connected and the connections
8 beeps Limit switch error: the
manoeuvre exceeded
the working time.
Check the limit switches and, in case, set them again
9/10 beeps One of the relay is
defective (see the
diagram at page 6)
Replace the control unit

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TELECO AUTOMATION TVRDS868B01 and is the answer not in the manual?

TELECO AUTOMATION TVRDS868B01 Specifications

General IconGeneral
BrandTELECO AUTOMATION
ModelTVRDS868B01
CategoryControl Systems
LanguageEnglish

Related product manuals