Telecom Behnke 10 Series Quick Reference Guide

18
Standard settingEntry (code / parameter) Function
LIFT EMERGENCY TELEPHONES
4
Configuration
Use internal configuration keyboard (open universal casing for this purpose).
Alternatively, configuration can also be done by DTMF telephone (touch-tone telephone).
Configuration is only possible with the a/b line (telephone line) connected.
Following the entry of each phone number and other configuration steps, do not forget to pr
ess the button!
In each case, finish configur
ation mode with . Otherwise it is possible that your entry is not stored correctly!!
(factory setting) Enable configuration mode
A button from to , then Direct-Call Button Response Delay
0 = none, 1 = 1 second, 9 = 9 seconds
A button from to , then Volume; 0 = low, 9 = high (full-duplex mode)
A button from to , then Volume; 0 = low, 9 = high (with add-on amplifier)
Note: Preferably use values between 1 and 4.
Number (4-digits max.), then 1st code for controlling relay 1
A button from to , then Group Call / Redial / Undroppable Call:
Number of phone numbers to be dialled
Phone number to be dialled, then 1st phone number in case of redial or: —
– in the case of 20-0018: phone number of the
button connected to the T1 contact (microphone and
LS in the telphone active).
– in the case of 20-0028: phone number of the emergency button
on the telephone for initiation on top of the car (integrated MLM).
Phone number to be dialled, then Phone number for MLM A (yellow jack) = inside the car or button —
connected to T2 contact or 2nd phone number in case of redial
Phone number to be dialled, then Phone number for MLM B (blue jack) = on top of the car (not in —
the case of 20-0028, because MLM is integrated on top of the car!)
or 3rd phone number in case of redial
Phone number to be dialled, then Phone number for MLM C (red jack) = underneath the car or —
4th phone number in case of redial
Phone number to be dialled, then 5th phone number in case of redial —
Phone number to be dialled, then 6th phone number in case of redial —
Phone number to be dialled, then 7th phone number in case of redial —
Phone number to be dialled, then 8th phone number in case of redial —
Phone number to be dialled, then 9th phone number in case of redial —
or phone number for button of the dial pad —
= not allowed, then Only when configuration is allowed can the
= allowed, then following configuration step be performed
= as a make contact, then T2 operational mode
= as a break contact, then T2 operational mode
End configuration mode
12345
∗
67890#
∗
T
E
L
#
#
0 6 0 9
#
0 9
#
0 9
#
#
#
0
5
0
0
0
0
9
0 7
1 0
2 0
n
n
0 0 0 0
For further configuration steps (relay control, sound settings, voice-announcement/real-time clock extension electron-
ics), please refer to our comprehensive technical manual (available as PDF on the Internet – see also note on page 2).
#
#
#
#
#
#
#
#
#
2 1
2 2
2 8
2 9
2 3
2 4
2 5
2 6
2 7
0 4
#
#
#
#
0 0
0
9
09
0
0
0
0
1
0
1
7
n

Telecom Behnke 10 Series Specifications

General

Brand	Telecom Behnke
Model	10 Series
Category	Intercom System
Language	English