How to adjust relay activation time on Telecom Behnke 5 Series?
If the relay on your Telecom Behnke Intercom System is activated for too short or too long a period, it's likely that the activation time is set incorrectly. You can adjust this by using configuration step 09 to set a suitable time in seconds.
Why is the relay not activating on my Telecom Behnke 5 Series?
There are a couple of reasons why the relay on your Telecom Behnke Intercom System might not be activating. First, the relay operations mode might be incorrect; use configuration step 08 to choose a suitable operations mode for a door relay, such as operations mode 4. Second, the telephone used for remote configuration may not be sending DTMF tones; remote configuration is only possible with a DTMF dialing telephone. Check with your intercom system support about sending DTMF tones.
Why does my Telecom Behnke 5 Series hang up with an error tone when a button is pressed?
If your Telecom Behnke Intercom System hangs up with an error tone when a button is pressed, it's likely that no number was entered for the direct call button. Configure a number using configuration step 21 or 22.
Installation instructions for specific Series 20/30/40/50 models.
Step-by-step guide for the mechanical mounting of Series 20/30.
Automatic IP address assignment via DHCP.
Manual IP configuration when DHCP is unavailable.
Resetting device using power-off/on and button presses.
Resetting device through the web interface.
IP configuration for Series 5/10 cameras (DHCP/Static).
Logging into the camera web interface with credentials.
Resetting the camera module to its default factory settings.
General| Brand | Telecom Behnke |
|---|---|
| Model | 5 Series |
| Category | Intercom System |
| Language | English |
To Next Page
