EasyManua.ls Logo

Teledyne 1000D User Manual

Teledyne 1000D
344 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
D-Ser ies Pumps
Installation and Operation Guide
Part #69-1243-969 of Assembly #60-1243-998
Copyright © 2013. All rights reserved, Teledyne Isco
Rev. F, July 2018

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Teledyne 1000D and is the answer not in the manual?

Teledyne 1000D Specifications

General IconGeneral
BrandTeledyne
Model1000D
CategoryWater Pump
LanguageEnglish

Summary

D-Series Pumps

Installation and Operation Guide

The primary guide for installing and operating the D-Series pumps.

Warnings and Cautions

Explosion Warnings

Important Safety Read

General Precautions and Cautions

Replacement Parts List

Section 1: Introduction

Specifications

Details the technical specifications for various D Series syringe pumps.

Controls and Indicators

Describes the front and rear panel controls and indicators of the pump controller.

Electrical Connections

Explains how to connect the pump controller and the pump to mains power.

Section 2: Fluid System Connections and Accessories

Fluid System Connections

Details port information and installation tips for fluid connections.

Section 3: Basic Programming and Operation

Section 4: Gradient Pumping for Pressure, Flow, and Concentration Modes

Connecting the System

Details how to connect the dual gradient system components.

Single-Pump Gradient Programming

Guides on programming pressure or flow gradients for a single pump.

Dual Pump Concentration Gradient Programming

Explains programming proportionate use of two fluids for concentration gradients.

Review, Revise, & Hold Options

Describes how to review, edit, or hold gradient programs.

Section 5: Continuous Flow Introduction, Installation, & Operation

Section 6: Modifier Addition

Section 7: Modbus Configuration

Section 8: Serial Interface

Serial Commands for the D Series Pump

Lists serial commands recognized by the pump for operation control.

Section 9: Pump Maintenance, Troubleshooting, and Servicing

Diagnostic Menu

Describes system tests initialized via the keypad.

Seal Cleaning and Replacement

Provides procedures for cleaning and replacing piston or wiper seals.

Overpressure Conditions

Discusses operator-settable pressure limits and shear key function.

Appendix A: Replacement Parts

Appendix B: Continuous Flow Introduction, Installation, and Operation for 30D

Continuous Flow Mode

Explains defining operation and using continuous flow modes for 30D pumps.

Warranty

Teledyne Isco One Year Limited Factory Service Warranty*

Outlines the terms and conditions of the one-year limited factory service warranty.

Related product manuals