Need help?Do you have a question about the Teledyne 260D and is the answer not in the manual?
General| Brand | Teledyne |
|---|---|
| Model | 260D |
| Category | Water Pump |
| Language | English |
Provides instructions for installing and operating D-Series pumps.
Explains safety symbols used in the manual and on the product.
Safety notes for using flammable fluids with SFX systems and D Series syringe pumps.
Warns about potential injury from pinch points in moving mechanisms.
Advises against using the instrument in ways not specified in the manual.
Recommends isolated environment for carcinogenic, biohazardous, flammable, or radioactive liquids.
Recommends a team lift to reduce injury risk when moving the instrument.
Explains how to connect power to the pump controller and pump.
Guides through a brief test of the pump’s operation after connections are made.
Details the functions of keys like CONST PRESS, PRGM GRAD, HOLD, RECALL, STORE, REFILL, LIMITS.
Explains the four multi-pump operating modes and independent mode.
Describes Constant Flow, Constant Pressure, Programmed Gradient, Dispense, and Refill modes.
Explains how to externally control the RUN/STOP function.
Explains how to connect inlets, outlets, and dual gradient systems.
Guides on programming single-pump gradients for pressure or flow.
Explains programming two-pump concentration gradients using flow mode.
Guides on defining operation, setting modes, and running/stopping pumps.
Guides on setting up pumps for modifier mode, including zeroing and filling.
Details setting pressure limits and modifier concentration.
Provides procedures for refilling the CO2 pump and the modifier pump.
Guides on accessing and configuring Modbus settings.
Explains network communication initiation and message framing.
Details connection schemes for one, two, or more controllers.
Guides on restoring defaults, changing defaults, and verifying operation.
Lists and describes serial commands for pump control.
Details diagnostic tests including LCD, Analog Inputs, Keypad, Motor, and Serial tests.
Explains how to remove the controller and pump case tops for access.
Details lubrication requirements for gears and ball nuts.
Provides procedures for cleaning and replacing piston and wiper seals.
Explains flushing the cylinder for gas solvent or liquid solvent changeover.
Explains overpressure protection and shear key function/replacement.
Details inspection, disassembly, and replacement of motor brushes.
Covers pressure transducer, A/D circuit, limit sensor, and electric valve motor calibrations.
Guides on defining operation, setting modes, and running/stopping pumps.
Details the one-year limited factory warranty covering parts and labor.
To Next Page
