What to do if Create TCP socket failed on Teledyne Sonar?
If the Teledyne Sonar fails to create a TCP socket, it means the operating system didn't allow the creation of network resources. To resolve this, verify your Windows installation, user settings, and network resources.
What to do if Teledyne Sonar could not create UDP server?
If the Teledyne Sonar could not create a UDP server, it indicates that a network resource was unavailable to the software from the operating system. You should check user permissions and network drivers to fix this.
Why Teledyne SeaBat T20-S could not create PCI server?
If the Teledyne Sonar could not create a PCI server, this may be due to errors in the configuration files or a corrupted installation. Try rebooting the PC. If the problem persists, call Teledyne RESON support.
How to fix ADMXRC configuration failed on Teledyne SeaBat T20-S Sonar?
If the ADMXRC configuration failed on your Teledyne Sonar, check the PCI bus drivers for the ADMXRC card.
Precautions for safe operation and handling by personnel.
Precautions for handling and protecting the system components.
Step-by-step instructions for starting the AUV and ROV systems.
Procedures for properly shutting down the AUV and ROV systems.
Instructions on starting and using the Sonar User Interface.
Explains how to use SUI controls to improve sonar performance.
How to select the appropriate range scale for optimal bottom image.
Importance of sound velocity for beamforming and performance.
Lists and describes error messages encountered by the system.
Startup errors and their corresponding actions.
An alphabetized master list of all system error messages.
Steps to verify the system is working properly after installation.
Details the terms of the three-year limited warranty.
To Next Page
General