Teledyne SeaBat T50-R User Manual

Use and Disclosure of Data
EU Uncontrolled Technology:
Information contained herein is uncontrolled under the EU-regulation no. 821 of 20 May 2021.
However, export, reexport or diversion contrary to law is prohibited.
SeaBat T-Series Rackmount
SeaBat T20-R and T50-R High-Resolution
Multibeam Sonar System
OPERATOR'S MANUAL
Part Number 1008754
Version 9
December 2021

Teledyne SeaBat T50-R Specifications

General

Number of Beams	512
Maximum Range	200 m
Angular Coverage	120°
Interface	Ethernet
Roll Stabilisation	Yes
Type	Multibeam

Summary

Introduction to SeaBat T-Series Rackmount

Safety Precautions

Operator Safety

General precautions for safe operation and handling of the sonar system.

Equipment Safety

Guidelines for ensuring the safety and protection of the sonar system components.

System Startup and Shutdown

System Startup Instructions

Step-by-step guide to powering on and starting the SeaBat sonar system.

Starting the Sonar User Interface

Instructions on launching and connecting to the sonar system's user interface.

Active Sonar Usage

Enhancing Sonar Performance

Guidance on adjusting settings to optimize sonar performance.

Correct Range Setting

Selecting the appropriate range scale for optimal bottom image display.

Receiver Gain

Adjusting receiver gain to optimize signal strength from returned signals.

Frequency Selection

Enhancing System Efficiency

Sound Velocity

Importance of sound velocity input for accurate beam steering and performance.

Appendix A Troubleshooting

System Error and Warning Messages

Overview of system error and warning messages and how to address them.

Error Messages

Appendix B Installation Instructions

Installation Checklist

A step-by-step checklist for installing the SeaBat sonar system.

Rack-mounted Sonar Processor (RSP) Setup

System Check

Procedures to verify the system is functioning correctly after installation.