What to do if Create TCP socket failed on Teledyne SeaBat T50-S?
If the Teledyne Sonar fails to create a TCP socket, it means the operating system didn't allow the creation of network resources. To resolve this, verify your Windows installation, user settings, and network resources.
What to do if Teledyne SeaBat T50-S could not create UDP server?
If the Teledyne Sonar could not create a UDP server, it indicates that a network resource was unavailable to the software from the operating system. You should check user permissions and network drivers to fix this.
Why Teledyne SeaBat T50-S could not create PCI server?
If the Teledyne Sonar could not create a PCI server, this may be due to errors in the configuration files or a corrupted installation. Try rebooting the PC. If the problem persists, call Teledyne RESON support.
How to fix ADMXRC configuration failed on Teledyne Sonar?
If the ADMXRC configuration failed on your Teledyne Sonar, check the PCI bus drivers for the ADMXRC card.
Precautions for user safety when operating the sonar system.
Precautions to prevent damage to system components.
Procedures to perform before deploying the sonar system.
Steps for starting the system for AUV and ROV configurations.
Procedures for safely shutting down the sonar system.
Instructions for starting and using the Sonar User Interface.
Techniques to improve sonar performance settings.
Lists system errors and warnings generated by the 7k Center software.
Detailed list of specific error messages and their causes.
To Next Page
General