EN 9
Operation of Bluetooth Hands-Free
You can make or receive phone calls with Bluetooth-enabled phones
through the unit. You can also listen to music from a Bluetooth-
enabled device.
Getting Started
Before use the Bluetooth device, you need to pair the device to the
unit. Pairing needs only to be done once.
Pairing the Bluetooth devices
1. Open your mobile phone and switch bluetooth on.
2. Search for other bluetooth device with your device.
3. Select “TELEFUNKEN” in the pairing list.
4. Input the password “0000”.
5. [Pairing OK] will be displayed on the screen if pairing is
successful, and the paired device will connect to the car audio
system automatically.
Disconnect the bluetooth
1. Press and hold
to enter into the [MENU] mode.
2. Once the [BT DISCONN] is displayed, press
to activate
the manual Disconnect mode.
Re-connect the bluetooth
1. Press and hold
to enter into the [MENU] mode.
2. Once the [BT CONNECT] is displayed, press
to activate
the manual Re-connect mode.
Making a Call
You can dial number through the mobile phone.
1. Use the Mobile Phone to dial and make an outgoing call.
2. Once completed the dialing, [CALLING] is displayed.
To redial number
1. Press
on front panel to redial.
2. Press
, unit will display [CALLING], and the unit starts
dialing the number dialed last time.
Remark:
To make an outgoing call on this unit, the bluetooth connection
between the unit and the phone must be active.
Receiving a Call
1. If there is incoming call, the phone number is displayed. if the
incoming call has no phone number, [PHONE IN] is displayed.
2. Press
to answer/accept the call.
3. When conversation ends, press
to terminate the call.
Call Transfer
You can transfer voice from loudspeaker to mobile phones during call.
During talking, press and hold
voice transfers from loudspeaker
to mobile phone.
Bluetooth Audio Streaming A2DP
If the connected Bluetooth device supports Advanced Audio
Distribution Profile (A2DP), you can listen to the music stored on
the device through the unit. If the device also supports Audio Video
Remote Control Profile (AVRCP) profile, you can use the control on
the unit or its remote control to play music stored on the device.
1. Press SRC repeatedly to select [BT AUDIO].
2. Press
to start play, press it again to pause.
3. To track up/down, press
.
Press to reject/end the call. Press to change to "BT AUDIO" mode.
■
Press to answer/accept the call.
■
Press and hold to transfer the call.
To Next Page
Loading...
Need help?
General
