Telepass SAT| Operating instruction v. 1.11 OCT 2020|© 2016-2020 Telepass 23
1. Adhere the Velcro strips to the
support.
2. Clean the application area on the
windshield carefully, using a
multipurpose detergent.
3. Remove the protective film from
the sticker.
4. Place the device horizontally on
the clean windshield.
5. Check for air bubbles in the
adhesive area. Press firmly the
device against the windshield.
Make sure the device does not impede vision when
driving and is outside of reach by moving parts and
airbags.
Avoid interferences
Leave at least 10 cm unobstructed space around the device
(free from shades or other objects).
Installing the device (mobile installation)
To ensure the Velcro strip adhesion, install the unit
when the ambient temperature is between 20 °C
and 40 °C.
EN
To Next Page
Loading...
