Televes Avant User Manual (English)

Other manuals for Televes Avant

Questions and Answers:

J
Joshua WarnerJul 28, 2025
Why are the channels in the broadband input of my Televes Avant Amplifier not equalised?
- S
  Sara WilliamsJul 28, 2025
  If the channels in the broadband input of your Televes Amplifier are not equalized with the programmable single-channels, make sure the input level is between 65 and 70 dBµV for UHF channels. Applying a level below this range will result in these channels having a lower level than the rest. A higher level may cause disturbances due to channel intermodulation.
C
christopherkimAug 1, 2025
What to do if the channels on my Televes Avant Amplifier are not adjusted to the programmed output level?
- W
  William CharlesAug 2, 2025
  If the channels on your Televes Amplifier aren't adjusting to the programmed output level, ensure the programmed single-channel in the highest output channel has an adequate signal and level. This is used as a reference for adjusting the selected output level.
K
Kim BrownAug 7, 2025
Why are the channels selected by BI/BIII on my Televes Amplifier not regulated correctly?
- B
  Bruce QuinnAug 7, 2025
  If the channels selected by BI/BIII on your Televes Amplifier are not regulated correctly, remember that the BI/BIII input is designed to amplify a broadcasted terrestrial channel. If you need to amplify signals in this band coming from satellite receivers, use the 'Wideband' input port.
E
Emily JacksonAug 12, 2025
What to do if my Televes Avant displays an error about programming two single-channels in the same RF output channel?
- S
  Sonya VincentAug 12, 2025
  If your Televes Amplifier shows the error message: 'The unit does not allow two single-channels to be programmed in the same RF output channel' when you press the adjustment button, press the button to exit this state. The remote control's display will indicate the first incorrect channel so you can modify it.
J
jtrevinoAug 17, 2025
What happens if I apply a collection of equalised channels from satellite receivers to my Televes Amplifier?
- J
  Joshua EnglishAug 17, 2025
  If you apply a collection of equalized channels coming from satellite receivers with the same level to your Televes Amplifier, the unit will treat them as a sole channel with a greater level, reducing the adjusted level of the collection compared to what you would have with one channel.
J
Jessica LarsonAug 22, 2025
What happens if I apply a sole channel in the BI/BIII input of my Televes Amplifier?
- R
  Rebecca VelazquezAug 22, 2025
  If you apply a single channel in the BI/BIII input of your Televes Amplifier, its level will be adjusted 5 dB below the level of the UHF channels.