Need help?Do you have a question about the Telrad CPE8000 and is the answer not in the manual?
General| Brand | Telrad |
|---|---|
| Model | CPE8000 |
| Category | Network Hardware |
| Language | English |
Step-by-step instructions for installing the CPE device, including connection and power-up.
Procedure for logging into the CPE's web interface using the default IP address and credentials.
Configuring LTE radio parameters, including band settings and frequency.
Setting up Access Point Names (APNs) for network connectivity and defining bearer profiles.
Adjusting MTU size and changing the device's operation mode from Router to Bridge.
Steps for upgrading the device firmware via HTTP, including warnings and reboot process.
Restoring the device to its original factory settings, requiring re-configuration.
To Next Page
