until the Switch Key is pushed back to the down position.
• When the call is connected the handset automatically enables Handsfree
(speaker-phone) mode.
• The alert tone volume can be adjusted to Off, Low, Medium or Loud
• In any state, push the Switch key down to return the phone to standby mode.
Switch Dialling is still activated when the keypad is locked.
• At the end of the call close the Switch Key to terminate the call.
3.2 MAKE AND RECEIVE CALLS
• Enter the phone number using the number keys and press the Green key to
dial. If you enter a wrong digit use the Red Key to delete. Long press the Red
key to clear all the characters and return to the idle screen.
• Press the * key twice to enter ‘+’ for international dialling.
• Press the * key three times for the Wait symbol ‘W’ which will hold dialling
until the next key is pressed.
• Press the * key four times for the Pause symbol ‘P’ which adds a 3 second
delay into the dialled number.
• Press the Green key to Answer an incoming call.
• Press the Red key to Reject an incoming call.
• Long press on the 0 key to enable Handsfree or Speakerphone mode
• Press the Volume keys to adjust volume during the call.
• Press the Red key to hang-up (End) the call.
• If you have set speed dial numbers long press the numeric keys (0, 2, 4 to 9)
To Next Page
Loading...
