[PL] Polish
Niniejszym TELTONIKA NETWORKS deklaruje że RUT300 jest zgodny z
zasadniczymi wymaganiami i innymi właściwymi postanowieniami Dyrektywy
2014/53/EU
[PT] Portuguese
Eu, TELTONIKA NETWORKS declaro que o RUT300 cumpre os requisitos
essenciais e outras provisões relevantes da Directiva 2014/53/EU
[RO] Romanian
Prin prezenta, TELTONIKA NETWORKS declară că aparatul RUT300 este în
conformitate cu cerinţele esenţiale şi cu alte prevederi pertinente ale Directivei
2014/53/EU
[SK] Slovak
Spoločnosť TELTONIKA NETWORKS týmto vyhlasuje, že smerovač RUT300 je v
súlade so základnými požiadavkami a ďalšími príslušnými ustanoveniami
smernice 2014/53/EU
[SI] Slovenian
TELTONIKA NETWORKS izjavlja, da je ta RUT300 v skladu z bistvenimi
zahtevami in drugimi relevantnimi določili direktive 2014/53/EU
[ES] Spanish
Por la presente, TELTONIKA NETWORKS declara que este RUT300 cumple con
los requisitos esenciales y otras exigencias relevantes de la Directiva
2014/53/EU
[SE] Swedish
Härmed intygar TELTONIKA NETWORKS att denna RUT300 är i
överensstämmelse med de väsentliga egenskapskrav och övriga relevanta
bestämmelser som framgår av direktiv 2014/53/EU
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference.1.
This device must accept any interference received, including interference that may cause2.
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
ISED Canada