FM TRANSMITTER REMOTE CONTROL AND
TELEMETRY SYSTEM SPECIFICATION
THE BLUE STAR FAMILY
Commands and alarms available by SMS
Commands:
♦ Forward power setting
♦ Transmitter power on
♦ Transmitter power off
♦ Alarms reset
♦ Transmitter working conditions
The Blue Star Family transmitters accept the above commands from every mobile phone
number, even if the GSM remote control mode has not been previously selected. It is not
requested to pre-set any phone number in the mobile memory.
As soon as the owner / technician sends a command to any transmitter, a SMS message
replies him, confirming if the command has been executed or not.
The Power off command sets to zero the forward power and the Power on command sets
the forward power to the value previously memory set.
The “transmitter working conditions” command will forward the following
information:
♦ Customer phone number
♦ Transmitter site
♦ Transmitter type and serial number
♦ Transmitter working (on air / fail)
♦ Frequency set
♦ Max forward power set
♦ Max reflected power set
♦ Forward power set
♦ Reflected power set
♦ Power module current
♦ Power module voltage
♦ Transmitter temperature
♦ Mains voltage
♦ Memory stored alarms
♦ End of SMS (character // )
To Next Page
Loading...