EasyManua.ls Logo

TEM A07A2200S - CHAPTER 2: Electrical Specifications

TEM A07A2200S
121 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A07A2200S
A07A2200S FM BROADCASTING
TRANSMITTER
ELECTRICAL SPECIFICATION
2.1 FREQUENCY - POWER
Frequency range ------------------------------------------------------------------------------ 87.6 to 107.9MHz
Frequency setting ------------------------------------------------------------------------------------10 Khz steps
Internal setting mode -------------------------------------------------------------------------------------- by keys
External setting mode --------------------------------------------------- by remote control ( RS232-RS485 )
Frequency stability ----------------------------------------------------------------------------------±250Hz/year
Frequency generation ---------------------------------------------------------------------------PLL synthesizer
Modulation type------------------------------------------------------------ direct VCO frequency modulation
Nominal frequency deviation --------------------------------------------------------------------------- ±75KHz
Deviation linearity in all frequency range --------------------------------------------------------------±0.2dB
Peak detector error------------------------------------------------------------------------------------------<0.1dB
RF output power -------------------------------------------------------------------------------------- 0 to 2000W
Power resolution setting --------------------------------------------------------------------------------------- 1W
Power control limit setting ------------------------------------------------------------------------10 to 2000W
Power control stability ------------------------------------------------------------------------------------< 0.1dB
Reverse output power control limit ------------------------------------------------------------------1 to 200W
Reverse output power steps control-------------------------------------------------------------------------- 1W
Harmonics emission-------------------------------------------------------------------------------------- <-70dBc
Spurious emission ---------------------------------------------------------------------------------------- <-95dBc
Carrier reduction power ( carrier enable off ) --------------------------------------------------------- >70dBc
2.2 MODULATION CAPABILITY
MONO (left and right) -------------------------------------------------------------------------- 30Hz to 15KHz
STEREO (by internal stereo generator) ------------------------------------------------------ 30Hz to 53KHz
SCA (two channels) ----------------------------------------------------------------------------30Hz to 100KHz
COMPOSITE ----------------------------------------------------------------------MONO or STEREO + SCA
2.3 CHARACTERISTICS IN MONO
Signal input--------------------------------------------------------------------------------------------Left + Right
Input impedance --------------------------------------------------------------------- 600? (balanced) or 10k?
Unbalance rejection ----------------------------------------------------------------------------------------->40dB
Input level------------------------------------------------------------------------------------------- 6 to +12dBm
Pre-emphasis --------------------------------------------------------------------------------------------75 or 50? s
Audio frequency response (30Hz to 15KHz)--------------------------------------------------------- <0.15dB
Audio frequency response ( 19KHz to 100KHz) ------------------------------------------------------<-40dB
Modulation distortion ------------------------------------------------------------------------------------- <0.03%
Signal to noise ratio ----------------------------------------------------------------------------------------->85dB
380 221 R02 Pag. 7