7
STEP 7
STEP 8
STEP 9
Carefully flip the base over on to its legs . Important: Two
people are required to move the bed base . Do not drag
across the floor . Do not rest frame on its side, excessive
pressure may damage the legs .
Plug the power cord into a power source . A surge protector
is recommended.
Ensure batteries are correctly installed in the back of the
remote .
Quickly test functions to verify proper setup before placing
mattress on base . Return the base to a flat position before
placing the mattress on top .
Setup is now complete! Test all functions on remote.
To install the mattress retainer bar, insert each end of the bar
into the holes at the foot of the platform .
installation guide
STEP 10
For customer support, call Customer Service: 1300 306 062, NZ: 0800 483 6789
To Next Page
Loading...
