Ten-Tec omni V 562 - User Manual

This obsolete manual file is provided as a courtesy to you by Ten-Tec, Inc.
Ten-Tec's service department can repair and service virtually everything we have built going
back to our first transceivers in the late 1960's. It is our ability to continue offering service on
these rigs that has led to their re-sale value remaining high and has made a major contribution to
our legendary service reputation.
Printed and bound copies of all manuals are available for purchase through our service
department if you would prefer not to use this copy as your transceiver manual.
We can repair or service your Ten-Tec equipment at our facility in Sevierville, TN. We also offer
support via telephone for all products via during usual business hours of 8 a.m. to 5 p.m. USA
Eastern time, Monday through Friday. We have a large supply of parts for obsolete products.
Repairing a transceiver or amplifier yourself? Contact us for parts pricing information.
Service department direct line: (865) 428-0364
Ten-Tec office line: (865) 453-7172
Service department email: service@tentec.com
Address: 1185 Dolly Parton Parkway, Sevierville, TN 37862 USA
We have found it is most effective for us to help you troubleshoot or repair equipment with a
consultation via telephone rather than by email.
Suggested contact methods are:
Troubleshooting or repairing equipment – call (865) 428-0364
Other inquiries – call (865) 428-0364 or email service@tentec.com
THANK YOU AND 73 FROM ALL OF US AT TEN-TEC

Summary

Installation

Fixed Station and Mobile Installation

Power Supply Connection

Instructions for connecting the DC power supply to the transceiver.

Antenna Connections

Details on connecting antennas to the transceiver's antenna port.

Microphone Connection

Information on how to connect the microphone to the transceiver.

Key Connection for CW

Ground Connection

Condensed Operating Instructions

Selecting Operating Frequency

Transmitting Procedures

Detailed Operating Instructions

Keypad Functions Overview

Explains keypad functions, mode selection, bandwidth, and controls.

Selecting Transceiver Mode

Crystal Filter Selection

VFO Selection and Offset Tuning

Band Selection Procedure

Memory Functions

How to store, recall, and manage memory channels.

Memory Store Operation

Memory Recall Procedure

Front Panel Functions

Describes the functions and operation of the front panel controls.

AF Gain and Tone Control

Noise Blanker Operation

Passband Tuning and Notch Filters

Rear Panel Functions Overview

Describes the connectors and functions on the rear panel.

Power Socket Details

Antenna Connection Guide

PTT Functionality

Operating Hints

Protective Circuitry and ALC

Information on protective circuitry and Automatic Level Control (ALC).

Circuit Descriptions and Illustrations

Transmit Lowpass Filter (81455)

Description of the transmit lowpass filter circuit.

Band Pass Filter Board (81409)

Description of the band pass filter board circuit.

XTAL OSC-LO Mixer (81408)

Description of the crystal oscillator-LO mixer circuit.

9 MHz Crystal Filter (81410)

Description of the 9 MHz crystal filter circuit.

Passband Tuning Board (81460)

Description of the passband tuning board circuit.

Control Board (81456)

Logic Board (81442)

RS232 Connector Board (81425)

Ten-Tec omni V 562 Specifications

General

Type	HF Transceiver
Operating Modes	SSB, CW, AM, FM
Input Power	13.8 V DC
Tuning Steps	10 Hz, 100 Hz, 1 kHz, 10 kHz
Power Output	100 W
IF Frequencies	9 MHz, 455 kHz
Selectivity	2.4 kHz @ -6 dB
Receiver Sensitivity	0.5 µV for 10 dB S/N
Image Rejection	>70 dB
Spurious Rejection	>70 dB