Tenda AC21 - Automatic Maintenance

177
12.12 Automatic Maintenance
Automatic maintenance enables you to make the router restart regularly. It helps improve the
stability and service life of the router.
To access the configuration page, log in to the web UI of the router, and choose System Settings >
Automatic Maintenance.
This function is enabled by default.
Parameter description
Parameter
Description
System Reboot
Schedule
It is used to enable or disable the automatic reboot function.
Reboot At
It specifies the time when the router reboot automatically every day.
Delay
It is used to enable or disable the delay function.
⚫
Ticked: The function is enabled. When the time for rebooting approaches, if there is any
user connected to the router and the traffic over the router's WAN port exceeds 3 KB/s
within 30 minutes, the router will delay rebooting. If there is any user connected to the
router and the traffic over the WAN port does not exceed 3 KB/s within 30 minutes, or
there is no user connected to the router and the traffic over the router's WAN port is
slower than 3 KB/s within 3 minutes, the router will reboot automatically.
⚫
Unticked: The function is disabled. The router enters the sleeping mode during the
sleeping time.
When the system reboot schedule function is enabled, the router detects the traffic over
the WAN port continuously within 2 hours after the specified reboot time and reboot
when the traffic requirement for rebooting is met.