Tenda GPON ONU - Configure Your Device

Internet
Setup
6
Step 2: Configure Your Device
1. Set your PC to an IP address within the following range: 192.168.1.X (2~254), and with the
subnet mask of 255.255.255.0. For specific steps, see 1 Configure PC.
2. Launch a browser, say IE, enter 192.168.1.1 in the address bar and press Enter.
3. Type in the default password admin (case-sensitive) on the pop-up login window and click
Login.
Tips:
1. If you’re failed to log in, please check your physical connections, and verify that all cables are
connected properly and all LED indicators are in normal status.
2. If you still cannot log in, please refer to Q1 of appendix 2 FAQs.
3. The default login password is admin. For better security, we strongly recommend you change it.
4. If wrong passwords are entered three times in a row, you have to wait for one minute to try to
log in again.