Tenda GPON ONU - Chapter III Function Brief; Internet Setup

Function
Brief
25
Chapter III Function Brief
1. Internet Setup
This page allows you to register your ONU device.
Parameters on this page are described below:
Parameter Description
Authentication
Type
After connecting the fiber to the ONU device, only when you have
authenticated your ONU device to the ISP OLT, can your ONU device access
the Internet. Three authentication types are available on this ONU device.
 LOID: The logical ID (LOID + LOID password) provided by your
ISP for registration. In some areas, no LOID password is needed. Just
leave the LOID Password field blank.
 SN: Serial number authentication.
 SLID: Password authentication.
Authentication
Status
Display the ONU’s current authentication status.
 Authenticated: The ONU has been authenticated successfully and
you can dial up to connect to the Internet.
 Not authenticated: Authentication failure. You can check whether the
LOID information you’ve entered is correct or not.
1.1 LOID
When LOID is selected, enter LOID and LOID password (In some areas, no LOID password is
needed. In this case, just leave the LOID Password field blank.) provided by your ISP for