Tenda M3 - Page 20

14
Parameter
Description

WPA-PSK: The security mode of the wireless network is WPA-PSK.

WPA2-PSK: The security mode of the wireless network is WPA2-PSK.

WPA-Enterprise: The security mode of the wireless network is WPA-Enterprise.

WPA2-Enterprise: The security mode of the wireless network is WPA2-Enterprise.
Encryption
It is available only when Security is enabled.
The AC supports the following three types of encryption:

AES: AES is short for Advanced Encryption Standard. This encryption algorithm ensures a higher
wireless rate.

TKIP: TKIP is short for Temporal Key Integrity Protocol. Wireless rate can only reach 54 Mbps with this
algorithm.

TKIP&AES: Compatible with TKIP and AES. The wireless client can use either AES or TKIP algorithm to
connect to the WiFi.
Security Key
It is available only when security is enabled.
Wireless clients need to enter this security key to connect to a corresponding AP.
The range of length is 8-63 characters.
Key interval
It is available only when security is enabled.
Configure the key update interval for encrypting WPA data. Theoretically, the shorter the key interval is,
the more secure the WPA data will be. If set to 0, the key will not be updated.
Client Limit For
SSID
Used to specify the upper limit allowed to connect to the corresponding SSID. Value range: 1-64.
Client Isolation
Enable/Disable client isolation.

Enable: Wireless clients that connect to the SSID cannot communicate with each other.

Disable: Wireless clients that connect to the SSID can communicate with each other.
SSID Hidden
Enable/Disable SSID Hidden function.

Enable: With this function enabled, the SSID will not be broadcasted so that the SSIDs can not be found
in the clients' available network list. Users need to manually enter the SSID to their clients connect to
the wireless network.

Disable: The SSID will be broadcasted and will be discovered by adjacent devices.
VLAN ID
Set VLAN ID of the SSID and all packets from connected clients will be tagged with this VLAN ID.
VLAN ID is not effective unless VLAN Policy is delivered.
Status
Display whether the policy is used or not.
Action
Modify the parameters except policy name.
You are not recommended to modify the Used policies.