Tenda M3 - Rear Panel; Label

2

LAN port
Five 10/100/1000 Mbps auto-negotiation RJ45 ports. Each RJ45 port has its corresponding Link/Act LED.

RESET button
When the AC is functioning properly, press it with a needle for about 6 seconds and then release; about 45
seconds later, this device will be restored to factory settings.
1.2.2 Rear Panel

Power Interface
Used to connect to the included power adapter for power supply.
1.2.3 Label
1 Default login IP address used to log in to this AC’s web UI.
2 Default login user name and password for web access.
3 This AC’s power specification.
4 S/N: If there goes something wrong with your device and you need to send it to our technical staff for repair,
you will need this sequence number.
1
3
4
2