26
Deployment Policy
This section helps you configure deployment policies, including Signal Transmission, Signal Reception, and
Ethernet Mode.
Click + Deployment Policy to add a deployment policy.
Parameter Description:
Enter a unique SSID deployment policy name. Duplicated names are not allowed.
Signal interference between APs can be effectively reduced by adjusting the transmit power of AP. If it
is a capacity-oriented network, please select High Density. Otherwise, select Coverage.
Select a Signal Reception Method based on different scenarios.
Coverage: It is used in a coverage-oriented network to ensure a higher WiFi coverage.
High Density: It is used in a capacity-oriented network to ensure a better signal quality.
Default: The signal reception is between coverage and high density.
Select AP LAN port's Ethernet mode. The default option is 10M Half-Duplex. This mode can transmit in
a longer distance with lower speed. When the distance between AP and the other device are more
than 100 meters, please select 10M half-duplex to make signal travels further. You must ensure that
the other device works in auto negotiation mode, or AP LAN port can't send and receive data.
To Next Page
Loading...